During this time of recession and falling home prices, there are things you can do to really improve the house is worth. Putting a fresh coat of paint on bathroom walls, repair any flaws, and updating plumbing fixtures, you can tired old bathroom into the new century, while bringing costs you very little. Very little, that is, with the exception of the bathtub. Although Bath scratched, chipped obtained, and stained over the years, they are very expensive and difficult to remove and replace. This iswhy many people choose a different method to reorganize their tubs. You refinish the tub instead of replacing them.
You can rework yourself and save even more money to do, you just need the right materials and supplies. The fumes from the chemicals that you use when refinishing a bathtub is very hard on your respiratory system. Therefore, you should make sure that the room you are working in well-ventilated and wear an effective face mask. If there are no windows inYour bathroom, you should always protect a respirator to the lungs. Additionally, having these things, you must have:
Bath * Dry cleaners for all residue from the bathtub strips
* A high-quality caulk bathroom
* Cover large sheet of paper (eg newspapers) or plastic to other things in the room
* Masking tape
* Acrylic Spray Gun
* A binder for use on porcelain
* Either primer or epoxy paint
* EP-AcrylicTopcoat
Start your makeover by removing all bathtub caulking around the tub. Then apply the chemical detergent for all residues from the surface to remove. It is extremely important that the surface quite so clean that the new surface coat to be able to maintain a strong bond forms.
Using the Palm Sander, you will sand the entire surface of the tub, creating an ideal surface, the fully comply with the new coat. During the grinding phase, you can also removeStains on the tub, such as chips, dents and scratches. Even though you may not be able to eliminate them completely, you should remove them as much as possible. Nevertheless, the surface by sanding, you create will have a major influence on the finished product.
After grinding, completely remove all substances from the surface of the tub. This includes the sanding dust and no water or chemicals that you used. Wearing a mask while cleaning are such that you reduce the amount of dust youinhale. The surface must be absolutely clean and dry before you apply the primer and the acrylic for the last layer.
Now that the tub is finished, you need to cover up other things in the room that you do not want to be able to get the tub surface material on. Since you will be spraying on it could end as good as anywhere, so it is best to take precautions before you go to work. With the tape and paper or plastic film covering the walls, the vanity and / or sink, the toilet, andeverything else in the room. You can set the floor with drop cloths or tarpaulins. Only when you are finished, everything is ready for you to go with your project.
0 ความคิดเห็น:
แสดงความคิดเห็น