Whether you are only interested in re-spraying a small area to cover some paint chips, or you want your car to a paint your own that you enjoy envious looks from every pedestrian you pass through treatment, you must follow a few basic rules and right tools at hand to carry out the work at a high level.
The first thing about car paint is worth noting that you should always work in a well ventilated area. Paint fumes can be a number ofSolvents that will make you feel light-headedness and even toxic if you inhale it, so make sure it's air flow when you paint with your work in the shop. You should also wear a respirator mask during painting or preparation to avoid inhaling any paint and loose dust that you post.
To get the best results when painting, you must also ensure that you are able to prevent dust to a minimum. You can achieve a good environment by hanging sheets from floorup to the ceiling in the area where you work, and wearing overalls. You should also vacuum the area where you paint the beginning of each session.
When you apply for auto body paint, is the main thing, a good finish that is to also get good looks, and the key to a good finish with a good start. Preparation is everything hurts. Get it right and you will be able to a fantastic smooth surface for the last few years and look great, enjoy your stint onPreparation, and your surface is unsightly straight away, and then over time get worse.
Before you paint, you have to take off the old paint. You can do this with a solvent in paint remover, or do it the hard way by sanding back the panels to bare metal with an orbital sander. Whichever method you choose, you must make sure that you have a very smooth base. To achieve this, use the finest grade sandpaper made available and be prepared to put serious time in the labor market.
OnceYou are satisfied with your base, you can apply the primer. HLVP Use a spray gun, an air compressor connected, since this is much more than an aerosol, and much cheaper in the long run. You should use long-drawn lines in a direction to get a good base to get to paint on. After each layer, let the paint dry and then sand it smooth on a surface. Then apply the next coat in strokes that at 90 degrees to be to the previous level, as this produce, tooColor.
There are two types of car paint, the paint you can use on a car, cellulose and two pack car. Most painters now two pack because it regain a better finish and metallic colors are available, whereas cellulose paint can be difficult to treat, and is best used on classic cars, where you try an older model.
How should the primer, the automatic color in layers are the syringes in a single direction, then loop back to remove a thin surfaceno deficiencies before the next layer at right angles to the previous one.
In between the layers, it is essential to clean the nozzles on your HVLP spray gun, as otherwise, small flakes of dried paint can in the spray and cause imperfections that will spoil the final effect is obtained.
When you are satisfied that you have a good covering and applied enough to have body paint layers to create an excellent finish to allow for another layer for the best effect, it dry, andSand again for a smooth surface. You should leave the paint to dry completely for 24 hours leave and then a wax polish on the entire body to protect your new paint job and is intercepted him a gloss, which certainly attracted the attention of all you will pass on the road.
0 ความคิดเห็น:
แสดงความคิดเห็น